Click the above photo to download a PDF data sheet.

The Model KAW6042 is a Class AB wideband RF power amplifier system delivering in excess of 5000 Watts CW power into a 50-Ohm load over the frequency range of 320-400 MHz. Power gain is a minimum of 66 dB. GPIB control requires the optional IEEE488.2/RS232 Interface Controller Module.

The system features forward and reflected power indication on a front panel-mounted, analog meter; Automatic Level Control (ALC); RF gain control; overdrive protection; full VSWR protection; input blanking, and over-temperature protection. On the basic model these features, plus remote power on/off control, are accessible for hard-wire remote operation through a 25-pin, D-subminiature connector. For a detailed description of these features refer to “SPECIAL FEATURES – KAA & KAW-SERIES SINGLE BAND RF POWER AMPLIFIERS”.

The system comprises eight Amplifier Units, a Power Controller Unit, two Combiner units and two Power Supply Units. These are installed on telescoping slides into a standard double, 19-inch equipment rack, 44 inches wide, 51 inches high, and 28 inches deep. The equipment rack is fitted with heavy-duty swivel casters. Each system component has integral forced-air cooling provided by highly reliable, impeller and/or tube-axial fans. The Model KAW6042 uses switching-type power supply modules and operates from 208 VAC, 47-63 Hz line, 3 phase. Power consumption is 20 kVA. The system may be placed in ‘stand-by’ mode with the BLANKING switch




• delivering in excess of 5000 Watts CW power into a 50-Ohm load over the frequency range of 320-400 MHz
• Automatic Level Control (ALC)
• full VSWR protection; input blanking, and over-temperature protection
• The system comprises eight Amplifier Units, a Power Controller Unit, two Combiner units and two Power Supply Units
• operates from 208 VAC, 47-63 Hz line, 3 phase

BACK TO AMPLIFIERS